Wings 3D Development Forum
[Fixed] Edge highlighting Perspective/Orthographic view - Printable Version

+- Wings 3D Development Forum (https://www.wings3d.com/forum)
+-- Forum: Wings 3D (https://www.wings3d.com/forum/forumdisplay.php?fid=1)
+--- Forum: Bug Reports (https://www.wings3d.com/forum/forumdisplay.php?fid=12)
+--- Thread: [Fixed] Edge highlighting Perspective/Orthographic view (/showthread.php?tid=2234)

[Fixed] Edge highlighting Perspective/Orthographic view - Loefet - 11-15-2016

When switching over to Orthographic view mode then the highlighting of selection and edge hardness disappears, and all edges turn black. You can get a faint green glow when hovering the pointer above them though, but nothing else.
Can't say on where this started, but it was this way when I installed 2.1.12 and also 2.1.13. Flushed my preference file to see if it was a local setting, but no change.

[Image: problem.jpg]
Left: perspective view of cube with one hard and one selected edge.
Right: same setting but in Orthographic view.

Hope this is something that can be sorted since I usually only use Orthographic mode when creating things.

EDIT: Forgot that I'm on a Win10 machine with an AMD A10 7850k, also running the 64bit version of Wings3D.

RE: Edge highlighting Perspective/Orthographic view - Fonte Boa - 11-15-2016

Maybe if you increase the value of "Selected Width" in
Preferences / Edge Display...

(just thinking loud...)

RE: Edge highlighting Perspective/Orthographic view - micheus - 11-15-2016

Dan, would it be related to the fix for this previous edge issue: http://www.wings3d.com/forum/showthread.php?tid=2196

RE: Edge highlighting Perspective/Orthographic view - dgud - 11-15-2016

Most probably, will take a look when I have time.

RE: Edge highlighting Perspective/Orthographic view - Loefet - 11-15-2016

(11-15-2016, 01:17 PM)Fonte Boa Wrote: Maybe if you increase the value of "Selected Width" in
Preferences / Edge Display...

(just thinking loud...)
That makes the Selections/Hardness visible, but there is still a black line overlaying the selection, if you know what I mean. Almost like a wire frame version of the object that is put to "always on top" around the object.
Could work as an interim solution, until a proper one is found.

Added some extra info about my system. And also tested both 32 and 64 bit versions of Wings3D to see if the problem was isolated to the 64 bit version, which I can report that it isn't, same thing on both.

RE: [Fixed] Edge highlighting Perspective/Orthographic view - dgud - 11-26-2016

Can you test and reply in thread