+- Wings 3D Development Forum (https://www.wings3d.com/forum)
+-- Forum: Wings 3D (https://www.wings3d.com/forum/forumdisplay.php?fid=1)
+--- Forum: Interface & Usage (https://www.wings3d.com/forum/forumdisplay.php?fid=3)
+--- Thread: how to connect a cylinder and a oblong box (/showthread.php?tid=1048)
how to connect a cylinder and a oblong box - WSR - 01-24-2015
hi to everyone,
new to this program, have not done any 3d modelling for quite a few years and that was with gmax.
was not sure how to do a search for this....
what i want to do is connect a cylinder to a oblong box that is in the middle.
when i rotate the cylinder in want the box to rotate with it.
many thanks for all the answers.
RE: how to connect a cylinder and a oblong box - micheus - 01-24-2015
In body selection mode [B] select the objects you Sant "connect" and use the context menu Combine.
You can separate them by using the Separate command.
Just in advise: if you named each object after you separate them they will get all the same name with a sequential number at the end.
If you just want rotate them together without combine them you can just change selection to vertex mode [V] and rotate them. (Change to vertex mode after select them in body mode first
)
RE: how to connect a cylinder and a oblong box - WSR - 01-25-2015
Thank You very much......