+- Wings 3D Development Forum (https://www.wings3d.com/forum)
+-- Forum: Wings 3D (https://www.wings3d.com/forum/forumdisplay.php?fid=1)
+--- Forum: Bug Reports (https://www.wings3d.com/forum/forumdisplay.php?fid=12)
+--- Thread: [fixed] Auto rotate and missing delay option (/showthread.php?tid=2414)
[fixed] Auto rotate and missing delay option - Hank - 02-21-2017
Hi guys,
Win 8.1
W3D 2.1.5
Hardware: i5 - 4310U/ Graphic Card: Intel HD
I tried to changes some values for Auto Rotate option and in comparison to 1.5.4 I can't find Delay option:
Additionally, even I try to change Angle values, rotation speed is always the same (very slow)
Could anyone confirm it?
Thanks.
BR, Hank
RE: Auto rotate and missing delay option - tkbd - 02-21-2017
Hi!,Hank.
In any case for value of angle , the initial speed was slow (In my Mac enviroment too).
And,You can change the rotation speed up or down with Push + or - key while Auto Rotation.
I have reported a bug relate to auto rotation earlier and it fixed.
To speed up for auto rotation makes app freeze.(Wings3D forum)
Delay option abolished after that,but I don't know why.
------------
tkbd
RE: Auto rotate and missing delay option - micheus - 02-22-2017
Hank, thanks for report that. Just a week ago I noticed that changing the Angle parameter has no effect in the rotation.
The tip by tkbd should be working (increase/decrease during rotation).
(02-21-2017, 02:53 PM)tkbd Wrote: Delay option abolished after that,but I don't know why.I'm going to share a answer I got from dgud
dgud Wrote:The old implementation was broken and could stall the whole machine if the model was
to large or used +/- to change the speed, so I changed it.
Now you don't change the speed, you change the rotation..
But it requires that erlang can draw the model in 60FPS, if it can't it will take longer time.
RE: Auto rotate and missing delay option - tkbd - 02-24-2017
Micheus,Thanks for reply.
Since that thread was only add with a [fixed] prefix,
So your information was help for me.
RE: Auto rotate and missing delay option - dgud - 02-25-2017
I have improved it, you can now set a larger default than 1 :-)