Scout wip - Printable Version +- Wings 3D Development Forum (https://www.wings3d.com/forum) +-- Forum: Wings 3D (https://www.wings3d.com/forum/forumdisplay.php?fid=1) +--- Forum: Gallery (https://www.wings3d.com/forum/forumdisplay.php?fid=10) +--- Thread: Scout wip (/showthread.php?tid=2640)

Scout wip - dasPoly - 04-02-2018 More to come. RE: Scout wip - micheus - 04-02-2018 Thanks for share your work. Are you modeling it in high resolution or is it just OpenCL subd in action? We alway appreciate to see the mesh. p.'s. The space available for attachments is very small. I suggest you look for an image hoster to show us your further images. RE: Scout wip - dasPoly - 04-02-2018 A little bit of both. There's a very simple base, but because it's round, if I make certain cuts in to low of res then sphere continuity breaks, so I smooth a step and add more cuts. Thats the high resolution mesh that I posted as a bake source, and am retopologizing it in Topogun to bring into substance. I'll update again once it moves a little farther. I've added the base, and the next level up where I cut in bottom detail and engines and some extra views. The rest is smoothing. RE: Scout wip - micheus - 04-02-2018 Thanks for show us your base mesh. The supposed final result in high res looks very nice. Just in case, do you know that you can use Flow Connect (in Edge mode) to keep the face curvature when adding details. It is useful most the times. RE: Scout wip - dasPoly - 04-03-2018 Yes, I use flow connect a lot. It's just large chunks taken out of the low res sphere can't maintain the curve @ corners after it's been smoothed. I would need ZBrush the take chunks out of a sphere while maintaining curvature at the corners or I would need to start at a higher resolution sphere in wings, kind of the same thing. and Thank You! Still more to learn.