+- Wings 3D Development Forum (https://www.wings3d.com/forum)
+-- Forum: Wings 3D (https://www.wings3d.com/forum/forumdisplay.php?fid=1)
+--- Forum: Bug Reports (https://www.wings3d.com/forum/forumdisplay.php?fid=12)
+--- Thread: [fixed] Sculpt + Wire mode (/showthread.php?tid=2696)
[fixed] Sculpt + Wire mode - Hank - 10-03-2018
Hi there,
W3D 2.1.7
Steps:
1. add any object
2. change mode to wire (W)
3. go to Sculpt
4. Start sculpting (just few clicks is enough)
5. turn off wire mode (W)
Can't get original shading - object is permanently in wire mode.
If you start sculpting in normal mode then it's OK.
BR, Hank
RE: Sculpt + Wire mode - micheus - 11-27-2018
That was fixed and will be available in the next release.