Wings 3D Development Forum
feature request: parametrize vs. coordinate value - Printable Version

+- Wings 3D Development Forum (https://www.wings3d.com/forum)
+-- Forum: Wings 3D (https://www.wings3d.com/forum/forumdisplay.php?fid=1)
+--- Forum: Gripes & Grumbles (https://www.wings3d.com/forum/forumdisplay.php?fid=4)
+--- Thread: feature request: parametrize vs. coordinate value (/showthread.php?tid=3215)

feature request: parametrize vs. coordinate value - Antonio.A - 02-20-2026

It is easier to make an example instead of explaining this feature: 
  1. Create a solid, e.g. a vertical cylinder.
  2. Cut vertical edges in 4 parts, then connect.
  3. Select all lateral nodes.
  4. Scale Radial >Radial Y > TAB
At this point, edit "50*Y" in the text box should scale radially the cylinder lateral nodes at 50% multiplied by their Y coordinate.

This would allow the creation of bodies, shaped as function of their nodes coordinates.
   
For example, the solid shown could be obtained by radial Y scaling by 50%*exp(Y)