+- Wings 3D Development Forum (https://www.wings3d.com/forum)
+-- Forum: Wings 3D (https://www.wings3d.com/forum/forumdisplay.php?fid=1)
+--- Forum: Interface & Usage (https://www.wings3d.com/forum/forumdisplay.php?fid=3)
+--- Thread: Separating after bridging (/showthread.php?tid=787)
Separating after bridging - SSE - 07-17-2014
I made the mistake of bridging the legs of my model to the body instead of using combine like I did with all the other parts later on. I imagine this would make the mapping a lot more difficult. Is there a simple way I can disconnect the legs I bridged to the body?
I attached an image.
Thanks in advance.
RE: Separating after bridging - micheus - 07-17-2014
You can select the edges surround the area you want to separate in two pieces (making a "loop") and use the context menu Loop Cut.
RE: Separating after bridging - SSE - 07-17-2014
That worked perfectly! I was looking for something like that. Thanks!