12-18-2012, 09:45 PM
(This post was last modified: 12-18-2012, 09:50 PM by puzzledpaul.)
returning to your original Qs ...or at least the car seat one, if I'd just had a brain transplant and decided to make a car model (not interested in them 
) ... I'd probably (also) consider drawing a profile of the seat ... and then extruding across its width.
linked page might provide some workflow possibilities.
<< But no forum topics, its annoying being linked to a forum topic and have to read through a bunch of stuff you don't need to find the one nugget of gold that you do >>
Unless, of course it's a thread that's been started by oneself, hoping to get specific, targetted responses to help solve modelling problems ... similar to this thread, in fact
pp
http://www.wings3d.com/paulthepuzzles/aa...trude.html
) ... I'd probably (also) consider drawing a profile of the seat ... and then extruding across its width.linked page might provide some workflow possibilities.
<< But no forum topics, its annoying being linked to a forum topic and have to read through a bunch of stuff you don't need to find the one nugget of gold that you do >>
Unless, of course it's a thread that's been started by oneself, hoping to get specific, targetted responses to help solve modelling problems ... similar to this thread, in fact
pp
http://www.wings3d.com/paulthepuzzles/aa...trude.html