10-03-2016, 05:04 PM
You need to Frezze the Mirror before you try to change one of the sides.
Wings 3D Development Forum
Wings 3D
Interface & Usage
Extrusion to a vertice
Extrusion to a vertice
|
|
![[Image: tw.png]](https://i.postimg.cc/QdjwyGVz/tw.png)
@MicheusVieira ![[Image: yt.png]](https://i.postimg.cc/WpJBDwQ5/yt.png)
@MicheusVieira ![[Image: da.png]](https://i.postimg.cc/xTvB5TjH/da.png)
Micheuss ![[Image: ig.png]](https://i.postimg.cc/4xMvhpC1/ig.png)
micheus4wings3d | Messages In This Thread |
|
Extrusion to a vertice - by rcrichfl - 10-03-2016, 03:48 PM
RE: Extrusion to a vertice - by micheus - 10-03-2016, 05:04 PM
RE: Extrusion to a vertice - by rcrichfl - 10-04-2016, 11:15 PM
RE: Extrusion to a vertice - by rcrichfl - 10-05-2016, 12:56 AM
|