01-08-2013, 06:25 PM
Micheus,
Thanks for fixing the problem with hard edges.
I think I need to read the entire thread from start to finish again...
When I add a sphere > convert object to area light > Reset view to Wings3D default view > Render, I see a portion of the sphere. Are you saying that the object being visible is expected behavior? Also, if I set edges to hard I see a couple of white lines running along the Y axis.
Just noticed that simply adding a sphere > Reset view to Wings3D default view > Render, gives you a couple of black lines running along the Y axis.
oort
Thanks for fixing the problem with hard edges.
I think I need to read the entire thread from start to finish again...
When I add a sphere > convert object to area light > Reset view to Wings3D default view > Render, I see a portion of the sphere. Are you saying that the object being visible is expected behavior? Also, if I set edges to hard I see a couple of white lines running along the Y axis.
Just noticed that simply adding a sphere > Reset view to Wings3D default view > Render, gives you a couple of black lines running along the Y axis.
oort