[Fixed] Vertex|Connect shortcut (C) in UV Window crashes Wings

[micheus]

Create a Cube.
Select one face.
Call RMB|UV Mapping.
In UV Map window, select that face, RMB click, Continue|Unfolding.
Select a pair of edges, hit "3" to divide them in 3 parts.

You did this cut in AutoUV Editor, right?

At this point, user is in Vertex mode (observing the workarea), but in UV Map window Wings seems to remain in Edge mode. It should change to Vertex mode...

so, that is not true if you use the older versions as 1.5.4. Which these shortcut cannot be used in AutoUV editor. The only ones available was Edit, View and Select menus shortcuts...

Then, click "C" (Vertex | Connect shortcut) and Wings will crash!!!

... and that is what is causing it crashes in AutoUV window.

Thanks for report the crash.