04-02-2017, 04:26 AM
micheus:
This is not produced by me intentionally. If you remember back in the days of wings 1.0.2, it used blue faces to signify faces that were not exported. Like this.
When Wings 2.0.5 or 2.1.5 loads the object, it looks like the one in the previous post.
And NO, it does not separate when you use the separate command. You cannot bridge faces that are connected at one side. If you look closely at the image, you can see both sides are connected by the doorway.
So I am still asking is there a way to close those tangent faces back up using wings 2.0.5 ?
Better yet, is there a way to block any wings version newer than 1.0.2 from even removing those faces? Anyways, this is why I am posting under grumbles because I have not been able to solve it without major effort for that last 5 years, especially if you have hundreds of missing faces in a file.
There is a workaround by going back to the ancient version and replacing the blue faces with the default and reloading it in the newer version. And then if I need to export, I make new holes that of course I don't know how to put back again. This is why I am still using a wings version from 2009.
This is not produced by me intentionally. If you remember back in the days of wings 1.0.2, it used blue faces to signify faces that were not exported. Like this.
When Wings 2.0.5 or 2.1.5 loads the object, it looks like the one in the previous post.
And NO, it does not separate when you use the separate command. You cannot bridge faces that are connected at one side. If you look closely at the image, you can see both sides are connected by the doorway.
So I am still asking is there a way to close those tangent faces back up using wings 2.0.5 ?
Better yet, is there a way to block any wings version newer than 1.0.2 from even removing those faces? Anyways, this is why I am posting under grumbles because I have not been able to solve it without major effort for that last 5 years, especially if you have hundreds of missing faces in a file.
There is a workaround by going back to the ancient version and replacing the blue faces with the default and reloading it in the newer version. And then if I need to export, I make new holes that of course I don't know how to put back again. This is why I am still using a wings version from 2009.