06-17-2017, 06:58 PM
(This post was last modified: 06-17-2017, 07:17 PM by StormEagle.)
I created the missing face by using the hole command. Then filled it in again. I also don't understand what you mean by "If you need "single" face grouped you must to use extract or extrude without thickness." because there is no thickness option for extrude or extract.
Can you explain how to do cleanup in body mode? I don't see how to do that.
Nevermind. I did the cleanup but the face was still missing.
Can you explain how to do cleanup in body mode? I don't see how to do that.
Nevermind. I did the cleanup but the face was still missing.