Weld Command and UV map

1 Vote(s) - 5 Average

Weld Command and UV map

micheus
Offline

Forum's Admin and Support | Bug fixer

Posts: 3,680
Threads: 184
Joined: Jun 2012

#11

09-14-2017, 09:13 PM

Just for share...

(09-13-2017, 10:17 PM)micheus Wrote: You probably will not smooth the object, so if you don't mind to have some extra and tiny faces close to the weld region then you could try to extrude a short amount the face that will be welded. But, use the Weld [RMB] and set the tolerance to a shorter value.
I'm not sure it would work, but you could try.

I tried and it "works". Extrude->Normal by 0 offset and in the Weld->Tolerance it was used 0.000:

[Image: tw.png]

@MicheusVieira [Image: yt.png]

[Image: yt.png]

@MicheusVieira [Image: da.png]

[Image: da.png]

[Image: ig.png]

micheus4wings3d
* Wings3D Team stands for: Björn and Dan

« Next Oldest | Next Newest »

Users browsing this thread: 1 Guest(s)

Messages In This Thread

Weld Command and UV map - by gap - 09-13-2017, 06:48 PM

RE: Weld Command and UV map - by micheus - 09-13-2017, 08:37 PM

RE: Weld Command and UV map - by gap - 09-13-2017, 08:55 PM

RE: Weld Command and UV map - by micheus - 09-13-2017, 09:08 PM

RE: Weld Command and UV map - by gap - 09-13-2017, 09:56 PM

RE: Weld Command and UV map - by micheus - 09-13-2017, 10:17 PM

RE: Weld Command and UV map - by gap - 09-13-2017, 11:13 PM

RE: Weld Command and UV map - by micheus - 09-14-2017, 01:34 AM

RE: Weld Command and UV map - by gap - 09-14-2017, 08:00 AM

RE: Weld Command and UV map - by micheus - 09-14-2017, 09:05 AM

RE: Weld Command and UV map - by micheus - 09-14-2017, 09:13 PM

RE: Weld Command and UV map - by micheus - 09-15-2017, 11:14 AM

RE: Weld Command and UV map - by gap - 09-21-2017, 12:37 PM