03-21-2019, 09:13 PM
Sorry, but I didn't understand your doubt.
The command - subject of this thread - is under main menu Select option.
The command - subject of this thread - is under main menu Select option.
Wings 3D Development Forum
Wings 3D
Interface & Usage
FACE REGION to (boundary) EDGE LOOP ??
FACE REGION to (boundary) EDGE LOOP ??
|
|
![[Image: tw.png]](https://i.postimg.cc/QdjwyGVz/tw.png)
@MicheusVieira ![[Image: yt.png]](https://i.postimg.cc/WpJBDwQ5/yt.png)
@MicheusVieira ![[Image: da.png]](https://i.postimg.cc/xTvB5TjH/da.png)
Micheuss ![[Image: ig.png]](https://i.postimg.cc/4xMvhpC1/ig.png)
micheus4wings3d | Messages In This Thread |
|
FACE REGION to (boundary) EDGE LOOP ?? - by Arg Arg - 03-17-2014, 04:18 PM
RE: FACE REGION to (boundary) EDGE LOOP ?? - by micheus - 03-17-2014, 04:35 PM
RE: FACE REGION to (boundary) EDGE LOOP ?? - by Arg Arg - 03-17-2014, 04:44 PM
RE: FACE REGION to (boundary) EDGE LOOP ?? - by digitaldavinci - 03-21-2019, 08:26 PM
RE: FACE REGION to (boundary) EDGE LOOP ?? - by micheus - 03-21-2019, 09:13 PM
|