04-13-2019, 10:12 AM
I had a question about theses tools.
I made a lot of tests with 1.5.4 to 2.2.4 with one or 2 or 3 cubes, with all the different options (ie, All, X, Y, Z, Radials X, Radial Y, Radial Z).
Apparently the Align Tools woks correctly in Object, Face, Edge or Vertex Mode, with 2 or 3 cubes with any selection on each cubes. The geometric Center is moved to the correct value (tested with Absolute Command).
But the Center Mode woks correctly only in Object Mode with one or several cubes.
When You select one face on one cube, Center tools works apparently as it was in Object Mode.
It gives the same result, as it was in object mode, and it is false with All, and one direction, depending of the selected face.
Idem, when you select one face on each cube.
It is a little bit disappointing.
Is that the correct way of Center Tools' work?
Regards
I made a lot of tests with 1.5.4 to 2.2.4 with one or 2 or 3 cubes, with all the different options (ie, All, X, Y, Z, Radials X, Radial Y, Radial Z).
Apparently the Align Tools woks correctly in Object, Face, Edge or Vertex Mode, with 2 or 3 cubes with any selection on each cubes. The geometric Center is moved to the correct value (tested with Absolute Command).
But the Center Mode woks correctly only in Object Mode with one or several cubes.
When You select one face on one cube, Center tools works apparently as it was in Object Mode.
It gives the same result, as it was in object mode, and it is false with All, and one direction, depending of the selected face.
Idem, when you select one face on each cube.
It is a little bit disappointing.
Is that the correct way of Center Tools' work?
Regards