Wings 3D 2.2.5 64-bit, Windows 10 1909 x64.
OK--it's been over a decade since I played around with Wings 3D, and it's been taking me a while to get back to speed. I noticed a problem with the Information Line freezing when making Command Menu choices.
For example: I select some elements, then Right Click to open the Command Menu;
Choose an item, say, "Move", at which point the sub-menu opens;
Hover over "Normal" and the Information Line reads "Move each element along its Normal..."
At this point the Information Line freezes and does not change when I select "Normal"; it should read "L: Accept__R: Cancel__[Tab] ..." In fact if you repeatedly Left (or Right) click followed by "D", eventually the Information Line will read correctly. This behavior is typical of most Command Menu options.
For what it's worth, the 32-bit version behaves the same. I also tried various Windows compatibility modes. Finally, I fired up a copy of version 1.4.1, and that behaved correctly!
OK--it's been over a decade since I played around with Wings 3D, and it's been taking me a while to get back to speed. I noticed a problem with the Information Line freezing when making Command Menu choices.
For example: I select some elements, then Right Click to open the Command Menu;
Choose an item, say, "Move", at which point the sub-menu opens;
Hover over "Normal" and the Information Line reads "Move each element along its Normal..."
At this point the Information Line freezes and does not change when I select "Normal"; it should read "L: Accept__R: Cancel__[Tab] ..." In fact if you repeatedly Left (or Right) click followed by "D", eventually the Information Line will read correctly. This behavior is typical of most Command Menu options.
For what it's worth, the 32-bit version behaves the same. I also tried various Windows compatibility modes. Finally, I fired up a copy of version 1.4.1, and that behaved correctly!