Kinda late but you can use the bounding box also, works pretty good. And another thing, just scroll out a few times, the grid becomes bigger (1cm). My models slices with the correct measurements on cura.
Wings 3D Development Forum
Wings 3D
Design & Development
STL support
STL support
|
|
| Messages In This Thread |
|
STL support - by imagine - 07-22-2020, 04:15 PM
RE: STL support - by oort - 07-22-2020, 05:59 PM
RE: STL support - by imagine - 07-22-2020, 07:56 PM
RE: STL support - by oort - 07-23-2020, 01:04 AM
RE: STL support - by imagine - 07-24-2020, 05:20 PM
RE: STL support - by micheus - 07-24-2020, 11:43 PM
RE: STL support - by oort - 07-28-2020, 06:41 PM
RE: STL support - by qewer3322 - 08-03-2020, 02:49 PM
|