04-16-2021, 04:54 AM
wings3d2021a00 Wrote:This should be the tutorial page I was referring to and the instructions. The image sharing info seems to not match google drive as this is the entire link below for you to open if desired.You are right and I just updated the instructions. Now that is the only link style that Google is generating, but you can try the old link I put there with was using '/open' and still works.
Anyway, the important information in that post is the reference to the ID they use - which I bold it in the link in your post.
You must to use the gdrive tag and that ID as shown in that instructions.
... and now, the image is shown exactly the page link I fixed in your first post.
wings3d2021a00 Wrote:As for the dimensions, yes, I can "compensate" but that's another roadblock to me learning the software. If I can not reproduce the educational material, then it is not as valuable as it could be.When I first started to access the old forum, back to 2009, this set of tutorials were already a legend (it was shared there in 2003). It's old, but all it's concept and commands should be valid. I don't know if someone someday already reported this kind of minor error, but I'll try to fix it ASAP.
Keep going. By following the puzzledPaul tutorials you must get the way Wings3D works - they are good for that.
Even if you decide to check some video tutorials, you probably will face many using old versions of Wings3D - in this case, the concept and commands are still the same, just they may look a little different due to the UI changes.
I'm going to let an example here in this tutorial to make a table too: Wings3D Tutorial - Beginners, Model a Simple Table by VscorpianC