03-18-2013, 06:19 PM
(This post was last modified: 03-18-2013, 06:20 PM by Misty Wisty.)
when i'm moving an adjacent vert,
or basically just rotating it around it's neighbor,
is there a way to constrain it so that it's connected edge retains it's length?
i see some axis constraint options.
trying to curve some verts around a tree trunk, starting from an image plane.
can't post a screenshot, used up all my allocated attachment usage
Thanks
or basically just rotating it around it's neighbor,
is there a way to constrain it so that it's connected edge retains it's length?
i see some axis constraint options.
trying to curve some verts around a tree trunk, starting from an image plane.
can't post a screenshot, used up all my allocated attachment usage
Thanks