03-26-2013, 07:28 PM
The scale you need will depend on the software you are importing the files into. I don't know what the scale should be and unless you can find someone who has done this before you will have to do a test file with a cube that is 1WU x 1WU x 1WU. I would think that the software that works with the 3d printer should be able to tell you what size it comes in as. If your 1x1x1 cube comes in at 2x2x2 then you need to set your scale to 0.5 but you will probably not be so lucky to have an exact number like that.... . I would also think that the 3D printer software would have the ability to scale the model up or down if it does not come in at the right scale. After your first model you would then know what scale to use...
oort
oort