07-19-2013, 09:05 PM
It is not only the three steps Micheus... it is that the connect tool in Wings produces results that are dependent on camera view. You can use the command in an 'align to selection' view (in orthographic mode) but even in such a case there would be problems when the selected points are far from each other, because they would become -as it is expected- invisible to the user.
Having a simple 'connect by shortest distance' command would solve all those problems. The whole idea was extremely simple: you just select two vertices on any area of the surface of a mesh and, then, you click 'connect by shortest distance'. Just in the way that it is implemented in Blender.
Below is the link of the request in the older forum:
http://nendowingsmirai.yuku.com/topic/78...empBm3hcYI
Having a simple 'connect by shortest distance' command would solve all those problems. The whole idea was extremely simple: you just select two vertices on any area of the surface of a mesh and, then, you click 'connect by shortest distance'. Just in the way that it is implemented in Blender.
Below is the link of the request in the older forum:
http://nendowingsmirai.yuku.com/topic/78...empBm3hcYI