11-18-2013, 12:22 AM
Micheus,
Sorry for the slow response. I have been away from my computer today. The problem is only obvious when you use an image that is not symetrical. An easy way to test is to use a Yafaray render with the settings badge turned on. Then you will see that the bottom view is flipped about the z axis instead of the x axis. I am thinking the settings badge should appear at the bottom (near to the camera/user). It would be as if the top view image plane is rotated 180 degrees about the X axis. Currently it is being flipped about the z axis. I think because your Kombi blueprints are symetrical we did not notice the problem before. Am I mistaken???
Thanks,
oort
Sorry for the slow response. I have been away from my computer today. The problem is only obvious when you use an image that is not symetrical. An easy way to test is to use a Yafaray render with the settings badge turned on. Then you will see that the bottom view is flipped about the z axis instead of the x axis. I am thinking the settings badge should appear at the bottom (near to the camera/user). It would be as if the top view image plane is rotated 180 degrees about the X axis. Currently it is being flipped about the z axis. I think because your Kombi blueprints are symetrical we did not notice the problem before. Am I mistaken???
Thanks,
oort