Foam insertion

2 Vote(s) - 5 Average

Foam insertion

Dimitri
Offline

Senior Member

Posts: 338
Threads: 39
Joined: Nov 2012

11-20-2013, 03:22 PM (This post was last modified: 11-20-2013, 03:22 PM by Dimitri.)

'There is a control that lets you specify how close to boundary a foam particle centroid is allowed.'

Where is it? The only two controls appearing in the tab are 'min proximity' and 'max proximity'. I did try both... none of them seems to make such a thing.

« Next Oldest | Next Newest »

Users browsing this thread: 4 Guest(s)

Messages In This Thread

Foam insertion - by ggaliens - 11-03-2013, 03:07 PM

RE: Foam insertion - by Dimitri - 11-19-2013, 08:54 PM

RE: Foam insertion - by ggaliens - 11-20-2013, 01:40 PM

RE: Foam insertion - by Dimitri - 11-20-2013, 03:22 PM

RE: Foam insertion - by ggaliens - 11-20-2013, 07:27 PM

RE: Foam insertion - by Dimitri - 11-20-2013, 09:42 PM

RE: Foam insertion - by ggaliens - 11-21-2013, 02:41 AM

RE: Foam insertion - by Dimitri - 11-21-2013, 03:32 PM

RE: Foam insertion - by Dimitri - 11-22-2013, 01:31 PM

RE: Foam insertion - by ggaliens - 11-23-2013, 10:56 PM

RE: Foam insertion - by Dimitri - 11-24-2013, 11:52 AM

RE: Foam insertion - by jotero - 11-24-2013, 12:46 PM

RE: Foam insertion - by Dimitri - 11-24-2013, 01:22 PM

RE: Foam insertion - by jotero - 11-25-2013, 02:16 PM

RE: Foam insertion - by Dimitri - 11-25-2013, 09:10 PM

RE: Foam insertion - by koipetta - 11-25-2013, 09:59 PM

RE: Foam insertion - by ggaliens - 11-25-2013, 11:18 PM

RE: Foam insertion - by ggaliens - 11-30-2013, 06:45 PM