11-21-2013, 02:41 AM
You mis-interpreted what I wrote.
Is the size of a TIDBIT is ... X (based on wings3d loading it and readings units).
Then if you use Min 1.2 and Max 3.5 and apply this to a model that is
60X units high .... then you might get foam about 3-5 tidmits deep (crust of foam)
hollow inside.
Scale your target model to larger if you want more foam inside it. Simple.
Think os MIN and MAX is being somewhat close to how many layers of
crust deep you want your foam.
Is the size of a TIDBIT is ... X (based on wings3d loading it and readings units).
Then if you use Min 1.2 and Max 3.5 and apply this to a model that is
60X units high .... then you might get foam about 3-5 tidmits deep (crust of foam)
hollow inside.
Scale your target model to larger if you want more foam inside it. Simple.
Think os MIN and MAX is being somewhat close to how many layers of
crust deep you want your foam.