11-29-2012, 10:14 AM
Hi PP
I understand what you are saying and I do agree, I did this model in Hexagon and a couple of techniques used were very useful, but I have the wings manual open
and will work through it.
Just another quickie (I did look in the manual and it wasn't there).
I bring in a cube, select a face, extrude the face a little, hit D to repeat the action, now what I want to do is to increase the size of the face bigger than the cube (sort of a scale command) but I just want the face only to extrude outwards.
is this possible ?
I understand what you are saying and I do agree, I did this model in Hexagon and a couple of techniques used were very useful, but I have the wings manual open
and will work through it.Just another quickie (I did look in the manual and it wasn't there).
I bring in a cube, select a face, extrude the face a little, hit D to repeat the action, now what I want to do is to increase the size of the face bigger than the cube (sort of a scale command) but I just want the face only to extrude outwards.
is this possible ?