Cut loop to two equal parts...

0 Vote(s) - 0 Average

Cut loop to two equal parts...

micheus
Offline

Forum's Admin and Support | Bug fixer

Posts: 3,686
Threads: 186
Joined: Jun 2012

#17

06-09-2014, 10:09 PM

(06-09-2014, 09:58 PM)Dimitri Wrote: 'In your illustrations using ropes it seems you expect to get a new loop cut parallel to other edge loops'
...
How did it came to you that I did refer to keeping a parallel position to the existent loops? I never mentioned such a thing.

You quoted it. Smile

Smile

Anyway, it's good to know I was wrong.

[Image: tw.png]

@MicheusVieira [Image: yt.png]

[Image: yt.png]

@MicheusVieira [Image: da.png]

[Image: da.png]

[Image: ig.png]

micheus4wings3d
* Wings3D Team stands for: Björn and Dan

« Next Oldest | Next Newest »

Users browsing this thread: 1 Guest(s)

Messages In This Thread

Cut loop to two equal parts... - by Dimitri - 11-28-2013, 04:30 PM

RE: Cut loop to two equal parts... - by micheus - 11-28-2013, 08:05 PM

RE: Cut loop to two equal parts... - by Dimitri - 11-28-2013, 09:06 PM

RE: Cut loop to two equal parts... - by micheus - 11-28-2013, 09:16 PM

RE: Cut loop to two equal parts... - by Dimitri - 11-28-2013, 09:34 PM

RE: Cut loop to two equal parts... - by ggaliens - 11-29-2013, 07:05 PM

RE: Cut loop to two equal parts... - by Dimitri - 11-29-2013, 09:36 PM

RE: Cut loop to two equal parts... - by ggaliens - 11-30-2013, 03:47 AM

RE: Cut loop to two equal parts... - by Dimitri - 11-30-2013, 05:27 PM

RE: Cut loop to two equal parts... - by Dimitri - 06-07-2014, 05:55 PM

RE: Cut loop to two equal parts... - by Arg Arg - 06-08-2014, 04:14 AM

RE: Cut loop to two equal parts... - by Dimitri - 06-08-2014, 12:41 PM

RE: Cut loop to two equal parts... - by Arg Arg - 06-08-2014, 01:36 PM

RE: Cut loop to two equal parts... - by Dimitri - 06-09-2014, 11:52 AM

RE: Cut loop to two equal parts... - by micheus - 06-09-2014, 05:38 PM

RE: Cut loop to two equal parts... - by Dimitri - 06-09-2014, 09:58 PM

RE: Cut loop to two equal parts... - by micheus - 06-09-2014, 10:09 PM