08-19-2014, 09:48 PM
Depending on where you're using it, you're sometimes able to set the texture to clamp, rather than repeat, which would get rid of "seams" near the edges of the texture. I don't know if you can in Wings3D though.
Wings 3D Development Forum
Wings 3D
Interface & Usage
'Snap image' mode -temporary hide
'Snap image' mode -temporary hide
|
|
| Messages In This Thread |
|
'Snap image' mode -temporary hide - by Radi - 08-17-2014, 12:43 PM
RE: 'Snap image' mode -temporary hide - by oort - 08-17-2014, 05:44 PM
RE: 'Snap image' mode -temporary hide - by Radi - 08-19-2014, 01:03 AM
RE: 'Snap image' mode -temporary hide - by Nova - 08-19-2014, 09:48 PM
RE: 'Snap image' mode -temporary hide - by tkbd - 09-29-2016, 11:23 AM
RE: 'Snap image' mode -temporary hide - by micheus - 09-29-2016, 01:16 PM
RE: 'Snap image' mode -temporary hide - by dgud - 09-29-2016, 06:53 PM
RE: 'Snap image' mode -temporary hide - by tkbd - 09-30-2016, 12:01 PM
|