Creating a hole in a cylinder off center

0 Vote(s) - 0 Average

Creating a hole in a cylinder off center

pashman
Offline

Junior Member

Posts: 8
Threads: 2
Joined: Oct 2014

#3

10-28-2014, 12:39 AM

(10-27-2014, 11:34 PM)micheus Wrote: You probably is looking for boolean operation. You can find a plugin for this in ggaliens' homepage.

I'm sure you are right. I will look for that.

« Next Oldest | Next Newest »

Users browsing this thread: 13 Guest(s)

Messages In This Thread

Creating a hole in a cylinder off center - by pashman - 10-27-2014, 11:23 PM

RE: Creating a hole in a cylinder off center - by micheus - 10-27-2014, 11:34 PM

RE: Creating a hole in a cylinder off center - by pashman - 10-28-2014, 12:39 AM

RE: Creating a hole in a cylinder off center - by Radi - 10-28-2014, 02:03 AM

RE: Creating a hole in a cylinder off center - by pashman - 10-28-2014, 10:32 AM

RE: Creating a hole in a cylinder off center - by Radi - 10-28-2014, 02:09 PM

RE: Creating a hole in a cylinder off center - by pashman - 10-28-2014, 02:48 PM

RE: Creating a hole in a cylinder off center - by micheus - 10-28-2014, 03:26 PM

RE: Creating a hole in a cylinder off center - by pashman - 10-28-2014, 03:41 PM

RE: Creating a hole in a cylinder off center - by micheus - 10-28-2014, 03:47 PM

RE: Creating a hole in a cylinder off center - by ggaliens - 10-28-2014, 05:03 PM

RE: Creating a hole in a cylinder off center - by pashman - 10-28-2014, 05:38 PM

RE: Creating a hole in a cylinder off center - by micheus - 10-28-2014, 07:37 PM

RE: Creating a hole in a cylinder off center - by Radi - 10-29-2014, 02:26 AM

RE: Creating a hole in a cylinder off center - by micheus - 10-29-2014, 01:26 PM

RE: Creating a hole in a cylinder off center - by marcusqueen - 11-03-2014, 06:43 PM

RE: Creating a hole in a cylinder off center - by sandralambert - 11-27-2014, 03:34 PM

RE: Creating a hole in a cylinder off center - by micheus - 11-27-2014, 04:24 PM

RE: Creating a hole in a cylinder off center - by Radi - 11-27-2014, 05:02 PM

RE: Creating a hole in a cylinder off center - by Geta-Ve - 12-12-2014, 09:15 AM