12-19-2012, 03:30 PM
ggaliens,
I installed your build last night. I noticed during installation there was a dialog that said my Microsoft Visual C++ 2008 X86 was not up to date. Shouldn't you be using 2010 instead? At least I think that is what is used in the official release. I aborted updating that when it told me that I first needed to close Outlook.
It is nice to see previews of the models before saying ok. I had to use Manual mode because my computer is old (Pentium 4 2.4GHz). I still think it would be better if it were possible to have simple dialogs i.e. Height: 2, Diameter: 4, Length: 8. As it is, I blindly change numbers in the formulas to see what happens...
oort
I installed your build last night. I noticed during installation there was a dialog that said my Microsoft Visual C++ 2008 X86 was not up to date. Shouldn't you be using 2010 instead? At least I think that is what is used in the official release. I aborted updating that when it told me that I first needed to close Outlook.
It is nice to see previews of the models before saying ok. I had to use Manual mode because my computer is old (Pentium 4 2.4GHz). I still think it would be better if it were possible to have simple dialogs i.e. Height: 2, Diameter: 4, Length: 8. As it is, I blindly change numbers in the formulas to see what happens...
oort