Without "Top Point Clamp" and "Botton Point Clamp" you will no be able to isolate the area to be deformed.
Take a look at this another video:
the intention is deform just the blue area.
Observe where i positioned "Center": this is important.
Observe too how i used "Top Point Clamp" and "Botton Point Clamp" to delimitate the area to be deformed.
Finally, observe that JUST that area was deformed: the rest rotates, but its volume is INTACT!
In your last picture (as the anterior two ones too), you are performing a Bend | Plastic Bend operation, not a real Bend Clamped | Clamped Plastic Bend.
http://www.youtube.com/watch?v=8egcNRNTp...e=youtu.be
Try to bend just the intermediate blue faces of your last picture, keeping the rest intact, generating an "U" shape, or an "L" one (with the corner rounded): you will need Bend Clamped!!! There is no way to simplify/unify this: the two commands are enterely differents!
Another approach to make you understand.
(i've created a text and Combine it with the bar, ok?!)
Left one was deformed by using Bend|Plastic Bend;
Right one by using Bend Clamped | Clamped Plastic Bend.
Obser how the letters at left were deformed
and how they are intact at right!
http://www.youtube.com/watch?v=FNa7SFpzu...e=youtu.be
Take a look at this another video:
the intention is deform just the blue area.
Observe where i positioned "Center": this is important.
Observe too how i used "Top Point Clamp" and "Botton Point Clamp" to delimitate the area to be deformed.
Finally, observe that JUST that area was deformed: the rest rotates, but its volume is INTACT!
In your last picture (as the anterior two ones too), you are performing a Bend | Plastic Bend operation, not a real Bend Clamped | Clamped Plastic Bend.
http://www.youtube.com/watch?v=8egcNRNTp...e=youtu.be
Try to bend just the intermediate blue faces of your last picture, keeping the rest intact, generating an "U" shape, or an "L" one (with the corner rounded): you will need Bend Clamped!!! There is no way to simplify/unify this: the two commands are enterely differents!
Another approach to make you understand.
(i've created a text and Combine it with the bar, ok?!)
Left one was deformed by using Bend|Plastic Bend;
Right one by using Bend Clamped | Clamped Plastic Bend.
Obser how the letters at left were deformed
and how they are intact at right!
http://www.youtube.com/watch?v=FNa7SFpzu...e=youtu.be
__________________________________
www.youtube.com/wings3dchannel
http://www.facebook.com/wings3dchannel
www.youtube.com/wings3dchannel
http://www.facebook.com/wings3dchannel