04-02-2016, 10:31 AM
OK, that's fine, I understand.
Basically, I've recently discovered W3D and I'm using it to make 3D sculptures & then print them out. Its been a steep learning curve though Ive got fairly good at it.
There are however 3 things I find myself wanting to do time and time again & unable to achieve in W3D2.02 (And TopMod seems to crash too often to be useable)
The key thing for me that would really help is the ability to set a group of selected different-length edges to a particular length , and I can't find a work-around. Any way to solve this would be great, even if I have to borrow a PC to do it.
So, is it included in the current ML release? Or was that a 'special' version you just knocked up to answer the OPs question?
Basically, I've recently discovered W3D and I'm using it to make 3D sculptures & then print them out. Its been a steep learning curve though Ive got fairly good at it.
There are however 3 things I find myself wanting to do time and time again & unable to achieve in W3D2.02 (And TopMod seems to crash too often to be useable)
The key thing for me that would really help is the ability to set a group of selected different-length edges to a particular length , and I can't find a work-around. Any way to solve this would be great, even if I have to borrow a PC to do it.
So, is it included in the current ML release? Or was that a 'special' version you just knocked up to answer the OPs question?