Help in bending a cylinder
|
04-06-2016, 06:28 PM
Oh no I just wanted this to make a special curve in a blade.
Btw how did you do it? And is it possible to just get a curve in 2 parallel sides Here is the thing I am talking about: http://i.imgur.com/7jKbIcc.png |
|
|
| Messages In This Thread |
|
Help in bending a cylinder - by Mancom37 - 04-06-2016, 05:20 PM
RE: Help in bending a cylinder - by cyseal - 04-06-2016, 06:05 PM
RE: Help in bending a cylinder - by Mancom37 - 04-06-2016, 06:28 PM
RE: Help in bending a cylinder - by cyseal - 04-06-2016, 06:32 PM
RE: Help in bending a cylinder - by Mancom37 - 04-06-2016, 06:36 PM
RE: Help in bending a cylinder - by cyseal - 04-06-2016, 06:42 PM
RE: Help in bending a cylinder - by Mancom37 - 04-06-2016, 06:45 PM
RE: Help in bending a cylinder - by micheus - 04-06-2016, 06:46 PM
RE: Help in bending a cylinder - by Mancom37 - 04-06-2016, 07:03 PM
|
