Sweep between 2 faces

1 Vote(s) - 5 Average

Sweep between 2 faces

cyseal
Offline

Member

Posts: 114
Threads: 19
Joined: Jan 2016

#1

01-22-2016, 11:44 AM (This post was last modified: 01-22-2016, 12:08 PM by cyseal.)

It is possible to sweep between 2 faces without calculating the angle and extruding?
When I sweep, it happens that the faces are not connected in the end because of a small angle or small amount of extruding.

Sweep result with 1 extrude,-10 degrees in z-axis. I would like to align 2 faces.
https://dl.dropboxusercontent.com/u/13451287/wcap1.PNG

I'm making https://www.youtube.com/watch?v=jBCwM898snU

« Next Oldest | Next Newest »

Users browsing this thread: 1 Guest(s)

Messages In This Thread

Sweep between 2 faces - by cyseal - 01-22-2016, 11:44 AM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 01:42 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 02:11 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 02:27 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 02:46 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 02:55 PM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 03:43 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 03:52 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 04:55 PM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 05:09 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 05:19 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 05:52 PM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 06:11 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 06:29 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 06:30 PM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 06:35 PM