Sweep between 2 faces

1 Vote(s) - 5 Average

Sweep between 2 faces

micheus
Offline

Forum's Admin and Support | Bug fixer

Posts: 3,657
Threads: 182
Joined: Jun 2012

#2

01-22-2016, 01:42 PM

(01-22-2016, 11:44 AM)cyseal Wrote: It is possible to sweep between 2 faces without calculating the angle and extruding?

No.
By considering the image, I would to say that you could to use a portion of 270 degree of a Cylinder (Tube); or extrude one face of the "cross", segment it and use blend to curve it; or you could Bridge the two faces of the "cross", select the new edges, cut them by n segments, select again the new edges and use Circularize by +/-270°.

[Image: tw.png]

@MicheusVieira [Image: yt.png]

[Image: yt.png]

@MicheusVieira [Image: da.png]

[Image: da.png]

[Image: ig.png]

micheus4wings3d
* Wings3D Team stands for: Björn and Dan

« Next Oldest | Next Newest »

Users browsing this thread: 6 Guest(s)

Messages In This Thread

Sweep between 2 faces - by cyseal - 01-22-2016, 11:44 AM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 01:42 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 02:11 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 02:27 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 02:46 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 02:55 PM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 03:43 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 03:52 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 04:55 PM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 05:09 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 05:19 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 05:52 PM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 06:11 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 06:29 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 06:30 PM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 06:35 PM