Sweep between 2 faces

1 Vote(s) - 5 Average

Sweep between 2 faces

cyseal
Offline

Member

Posts: 114
Threads: 19
Joined: Jan 2016

#9

01-22-2016, 04:55 PM (This post was last modified: 01-22-2016, 05:05 PM by cyseal.)

Thanks, nice flow.

After you cut and connect, what two edges did you select ?
I can't get the correct loop ring to circularize.

« Next Oldest | Next Newest »

Users browsing this thread: 4 Guest(s)

Messages In This Thread

Sweep between 2 faces - by cyseal - 01-22-2016, 11:44 AM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 01:42 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 02:11 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 02:27 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 02:46 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 02:55 PM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 03:43 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 03:52 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 04:55 PM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 05:09 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 05:19 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 05:52 PM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 06:11 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 06:29 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 06:30 PM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 06:35 PM