Sweep between 2 faces

1 Vote(s) - 5 Average

Sweep between 2 faces

micheus
Offline

Forum's Admin and Support | Bug fixer

Posts: 3,657
Threads: 182
Joined: Jun 2012

#10

01-22-2016, 05:09 PM

(01-22-2016, 04:55 PM)cyseal Wrote: After you cut and connect, what two edges did you select ?

For the Circularize option?
They are two segment from the initial edge we cut - the corners. Notice that after that we use Edge Loop that will select all the segments cut from that initial edge.

@MicheusVieira [Image: yt.png]

@MicheusVieira [Image: da.png]

Micheuss

micheus4wings3d
* Wings3D Team stands for: Björn and Dan

« Next Oldest | Next Newest »

Users browsing this thread: 1 Guest(s)

Messages In This Thread

Sweep between 2 faces - by cyseal - 01-22-2016, 11:44 AM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 01:42 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 02:11 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 02:27 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 02:46 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 02:55 PM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 03:43 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 03:52 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 04:55 PM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 05:09 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 05:19 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 05:52 PM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 06:11 PM

RE: Sweep between 2 faces - by cyseal - 01-22-2016, 06:29 PM

RE: Sweep between 2 faces - by Fonte Boa - 01-22-2016, 06:30 PM

RE: Sweep between 2 faces - by micheus - 01-22-2016, 06:35 PM